Honeywell UltraKey Lite HJC5000 User Manual

Document 800-07422 – Rev A – 08/10
Installation and User Guide
UltraKey Lite
Keyboard controller for VideoBloX
and MAXPRO-Net Matrix Systems
HJC5000

Honeywell UltraKey Lite HJC5000 Specifications

General

Connection Type	USB
Key Switch Type	Membrane
Dimensions	17.6 in x 6.4 in x 1.3 in
Weight	1.4 lbs
Number of Keys	104
Spill Resistant	Yes
Operating System	Windows
Cable Length	6 ft

Summary

Important Safety Instructions

Installation and Electrical Safety

Covers safe installation practices and electrical hazard avoidance.

Environmental and Servicing Safety

Addresses safe placement, cleaning, and servicing procedures.

UltraKey Lite Port Descriptions

Serial Port and Connectivity Options

RS232, RS422/485 Serial Port

Explains serial port usage and specifications.

Terminal Box and USB Port

Using the UltraKey Lite Controller

Logging Onto the Controller

Navigating LCD Menus

VideoBloX Key Functions

MAXPRO Key Functions

Installing UltraKey Lite with VideoBloX

Configuring Serial Connection for VideoBloX

Step 2: Configure Controller for VideoBloX Mode

Configuring VideoBloX Address, Baud Rate, or IP

Configuring VideoBloX Default Settings

Configuring Ethernet Connection for VideoBloX

Setting Up Ethernet Connection for VideoBloX

Configuring Controller for Ethernet Connection (VideoBloX)

Setting Keyboard Address for VideoBloX

Configuring UltraKey Lite for VideoBloX Mode

Configuring VideoBloX Network Settings

Serial Port Connection Configuration (VideoBloX)

Ethernet Connection Configuration (VideoBloX)

Configuring Dynamic Keys in VideoBloX

Installing UltraKey Lite with MAXPRO-Net

Navigating LCD Configuration Menus

Configuring Serial Connection for MAXPRO

Step 1: Connect via Serial Port

Instructions for establishing a serial connection.

RS422 Converter and Terminal Box Setup

Configuring Controller for MAXPRO Mode

Configuring MAXPRO Address, Baud Rate, or IP

Configuring Ethernet Connection for MAXPRO

Step 1: Connect via Ethernet Port

Instructions for establishing an Ethernet connection.

Setting Up Ethernet Connection for MAXPRO

Configuring Controller for MAXPRO Mode (Ethernet)

Configuring Controller for Ethernet Connection (MAXPRO)

Setting Keyboard Address for MAXPRO

Configuring UltraKey Lite for MAXPRO Mode

Configuring MAXPRO Network Settings

Serial Port Connection Configuration (MAXPRO)

Ethernet Connection Configuration (MAXPRO)

Configuring Dynamic Keys in MAXPRO

System Administration and Troubleshooting

System Administration via Controller LCD

Guides system management through the controller's LCD.

Logging into System Set: Config Menu

Setting Screen Language

Hardware Testing and Default Restoration

Testing the Hardware

Procedures for testing controller hardware components.

Restoring Factory Defaults

Steps to reset the controller to its default settings.

System Administration via Web Browser

Upgrading UltraKey Lite Firmware

Guide for updating the controller's firmware.