Honeywell VisionPRO TH8000 Series - Post-Installation Setup and Testing

Installation Guide
Remove tab and mount thermostat
Remove tab.
Align pins on back
of thennostat with
slots
in wall plate, then push gently
until thennostat snaps into place.
Set date and time
Press ..... ~
to set date
Press
..... ~
to set month
Press
A~
to set year
Press
DONE to save changes.
Press
DONE to save and exit.
Installer setup
1. Press SYSTEM.
2. Press and hold
these
two buttons
until the display
changes.
3. Change settings
as required (see
pages
7-9).
6