Honeywell VisionPRO TH8000 Series - Page 9

VisionPRO® TH8DDD Series
Press FAN
Note: If a fan schedule is programmed,
"Auto" will run the fan schedule.
Press FAN to select fan operation, then press
DONE.
• On: Fan is always on.
• Auto: Fan runs only when the heating or
cooling system is on.
• eire: Fan runs randomly, about 35% of the
time, not counting any run time with the
heating
or cooling system.
You can press FAN to override the fan settings
you've programmed
for different time periods
(see page 11). If you select On
or Circ, the
setting you select will remain active until you
press
FAN again to select Auto (see page 27
for more information).
7