How to fix Honeywell VXP DU and AU connection timeout?
If you see the “Time Out!!! VXP is still waiting for Acquisition Unit...”, it could be due to several reasons. First, ensure the serial cable is properly connected. Next, verify that the AU power is turned on. If the issue continues, try cycling the AU power and reconnecting. If problems persist, download and review the VXP fault log for further insights and save it for future reference.
What to do if Honeywell VXP shows 'ACQUISITION ERROR NO MAG PICKUP'?
If you're seeing an “ACQUISITION ERROR NO MAG PICKUP” message, start by checking that the magnetic pickup cable is securely connected to both the sensor and the correct input on the AU. Also, ensure the gap between the magnetic pickup and the interrupter is properly set to 0.05 in. ±0.01in.
Why does my Honeywell Analytical Instruments display the “VXP Out Of Sync” message?
If the “VXP Out Of Sync” message appears, it means the AU is out of sync with the DU. To resolve this, cycle the AU power and then reconnect.
What to do if Honeywell VXP Analytical Instruments serial printer fails to print?
If the serial printer fails to print from the AU, first check that the serial cable is connected. Then, make sure the printer is turned on and that its power is properly connected, ensuring the battery isn't too low. Additionally, verify that the correct printer is selected in the DP by going to the File menu in the DP main window, selecting Print (AU Printer), and choosing the desired logs from the Print Menu.
How to fix Honeywell VXP 'Access is Denied' message?
If you receive an “Access is Denied” message when connecting the DU to the AU, the wrong COM port may be selected in the DP. To correct this, go to the Comm menu in the DP main window, select Comm Port Settings, and choose the correct COM port.
What to do for Honeywell VXP Analytical Instruments Non-recoverable Hardware Failure?
To address a Non-recoverable Hardware Failure, cycle the VXP power off and then on again. If the problem continues, replace the VXP AU. Remember to keep copies of downloaded Fault Logs and a record of the events leading up to the failure.
Details the purpose and operational capabilities of the VXP system.
Describes the physical components and accessories of the VXP system.
Outlines the conditions under which the VXP system can be operated.
Provides guidelines for safely storing and shipping the VXP system.
Information on the standard warranty for the VXP system.
Step-by-step instructions for safely unpacking the VXP system.
Procedures for preparing the VXP system for initial operation.
A checklist to ensure all VXP hardware and software are operational.
Provides a system overview and block diagram of the VXP.
Details the manual operation procedures for the VXP system.
Lists necessary test equipment and accessories for VXP maintenance.
Procedures for inspecting VXP components for proper operation.
Instructions for performing performance tests on VXP system components.
Guide to identify and resolve common VXP system problems and error codes.
Step-by-step procedure for replacing the VXP AU battery.
Guidelines for inspecting, testing, and repairing VXP system cables.
Procedures for cleaning VXP system components and surfaces.
Instructions for properly repacking VXP components into the carrying case.
Procedures for shipping individual VXP components for repair.
Guidelines for long-term storage of VXP components.
General| Moisture Range | 1 ppm to 100% |
|---|---|
| Measurement Range | 1 ppm to 100% |
| Titration Method | Volumetric Karl Fischer |
| Sample Type | Liquids, solids, and gases |
| Display | Touchscreen LCD |
| Data Storage | Internal memory, USB export |
| Connectivity | Ethernet, USB, RS-232 |
| Power Supply | 100 to 240 VAC, 50/60 Hz |
| Certifications | CE |
To Next Page