Hoogo B3+ - Page 32

Instruction Manual hoogo B3+
Operation
E
30
cable back in up to the yellow marking using the
cable winding button.
2. Plug the plug into a socket.
3. Press the on/o switch (Fig. 1, no. 10) to turn the
appliance on.
4. Adapt the suction power to the base to be vacu-
umed via the suction power regulation (Fig. 1, no. 9).
Ö Activate the auxiliary air regulator (Fig. 1, no. 5), if an
item has been accidentally drawn or sucked in.
4.2 Switching o and retracting mains
cables
1. Press the on/o switch (Fig. 1, no. 10) to turn the
appliance o.
2. Unplug the plug from the wall socket.
3. Hold the mains cable plug in your hand.
4. Press the cable winding button (Fig. 1, no. 4).
5. When drawing it in, guide the plug towards the
cable winding in order to avoid the mains cable
moving from side to side.
4.3 Keeping and storage
ATTENTION
Property damages!
The appliance may be damaged by heat.
►
Do not place the appliance directly next to heat
sources (e.g. heating or ovens).
►
Avoid direct insolation.
4.3.1 Storing the appliance
1. Ensure that the appliance is switched o („4.2
Switching o and retracting mains
cables“ on page 30).
2. Insert the parking hook on the universal floor nozzle
(Fig. 1, no. 15) into the parking fixture on the reverse
side of the appliance.
4.3.2 Storing the appliance
1. Ensure that the appliance is switched o („4.2
Switching o and retracting mains
cables“ on page 30).
2. Place the appliance upright so that the carrying
handle is at the top and the reverse side of the
appliance is accessible.