Hoogo B3+ - Page 35

Instruction Manual hoogo B3+
Cleaning and maintenance
33
2. Press the locking mechanism on the vacuum clean-
er lid (Fig. 2A).
3. Open the vacuum cleaner lid.
4. Remove the dust bag (Fig. 2B).
5. Flap the filter holder open (Fig. 3A, p. 97).
6. Remove the motor filter (Fig. 3A).
7. Beat the filter above the dustbin and rinse the filter
using clear water (Fig. 3B).
8. Let the filters dry completely in the fresh air or on
a radiator (Fig. 3C). Let the filter dry for at least 24
hours on a radiator. Drying in the fresh air may take
up to 72 hours. If necessary, use replacement filters
during this period. They can be ordered on the In-
ternet or via our service department („6 Spare parts
and accessories“ on page 35).
9. Insert the clean motor filter into the filter holder.
10. Close the filter holder until it engages audibly and
noticeably (Fig. 3D).
5.3 Cleaning the exhaust filter
INFORMATION
Property damages!
The exhaust filter can be damaged by water and
heavy soiling.
►
Clean the exhaust filter only dry by beating it and
brushing it carefully.
► Clean the filter regularly, however at the
latest when vacuuming performance worsens
significantly.
Follow the action steps listed to clean the exhaust filter
(Fig. 1, no. 19).
1. Ensure that the appliance is switched o („4.2
Switching o and retracting mains
cables“ on page 30).
2. Press the locking mechanism on the vacuum clean-
er lid (Fig. 1, no. 7).
3. Open the vacuum cleaner lid.
4. Press the locking mechanism on the exhaust filter
cover and flap the exhaust filter cover open.
5. Remove the exhaust filter (Fig. 1, no. 19).