Hoogo B3+ - Page 38

Instruction Manual hoogo B3+
Rectification of faults
E
36
Problem Possible cause Solution
The dust filling
level display is
fully blue.
The dust bag is
overfilled.
Replace the dust bag
(„5.1 Replacing the dust
bag“ on page 32).
The appliance
only cleans a
little of the dirt.
The dust bag is
overfilled.
Replace the dust bag
(„5.1 Replacing the dust
bag“ on page 32).
The filters are
soiled.
Clean the filters („5.2
Cleaning the motor fil-
ter“ on page 32, „5.3
Cleaning the exhaust
filter“ on page 33).
The nozzle used is
inappropriate for
the surface.
Use the fitting nozzle
for your surface („3.3.2
Assembling the nozzles“
on page 26).
The vacuuming
performance set
is inappropriate
for the surface.
Set the correct suction
performance („4.1 Vac-
uum cleaning“ on page
29).
A hindrance
exists.
Check whether the
nozzle, suction tube,
hand grip or hose is
blocked and remove
the hindrance.
Problem Possible cause Solution
The appliance
cover cannot
be closed.
The dust bag is
protruding and
hinders the cover
from closing fully.
Check the correct posi-
tioning of the dust bag.
Ensure that the correct
bag type has been
inserted.
The appliance
suddenly stops
vacuuming
The integrat-
ed overheating
protection has
been activated
(possibly due to
an overfilled dust
filter bag).
Proceed as follows:
1. Switch the appliance
o.
2. Unplug it.
3. Rectify the cause of
overheating (replace
the dust bag, clean the
filter, remove blockag-
es).
4. Close the appliance
again if applicable and
put the accessories into
place.
5. Wait for approx. 45
minutes.
6. Commission the
cooled-down appli-
ance.