Secret sorcery (beta)
No rights can be claimed by using this function.
We made it as stable as possible, but with very extreme settings it is possible that the unit
crashes.
So, for the lovers of sorcery:
It is possible to morph between every corresponding A and B memory location.
For instance, preset 1A and 1B.
Make to settings with the same channel and voicings (gain, bass, mid, treble, volume, reverb)
Connect an expression pedal to your midi foot controller,
Select midi channel, which was selected for the Wizard, CC1 (control change command)
Heel down corresponds with preset 1A and toe down with preset 1B.
Example
Preset 1A: channe1, low gain setting, hi volume setting, low reverb
Preset 1B; channel1, high gain setting, low volume setting, hi reverb
High resolution speaker simulator
• Gnd lift. Push in for a lift, in case you experience hums or high pitched noise when
connected to other earthed devices
• Mic/Line. Adjust the output level. When pushed the level is high.
• If you convert XLR to mono jack , you short circuit 1 phase , and the difference between
line and mic level gets very small. Use a stereo jack to prevent this issue.
To Next Page
Loading...