Hoonved HD BT - Troubleshooting

41
Part 2: For the operator
ENGLISH
TROUBLESHOOTING
PROBLEMS CAUSES SOLUTIONS
The machine fails to
come on.
The machine does not ll
with water
Insufcient washing
Insufcient rinsing.
Main switch disconnected.
Water cock shut.
Fill pipe lter dirty.
Rinsing nozzles clogged.
Overow pipe incorrectly inserted.
Washing lter dirty.
Washing nozzles clogged.
Washing rod clogged.
Insufcient or no detergent.
Machine temperature not reached.
Washing conditions insufcient.
Rinsing nozzles clogged.
Boiler clogged with scaling.
Low mains pressure (less than 200 kPa).
Temperature insufcient.
Incorrectly positioned nozzles or
nozzles deformed.
Turn on the switch.
Turn on the cock.
Detach the ll pipe (16 Fig. 5) and clean the lter.
Unscrew and clean the nozzles (22 Fig. 6) under running
water.
Make sure that the overow pipe (13 Fig. 5) has been cor-
rectly inserted.
Clean the lter (19/25 Fig. 6).
Demount and clean the washing nozzles under running water.
Demount and clean the rod (20 Fig. 6).
Top up the detergent in the canister and check its concen-
tration.
Wait until the tank water has reached the right temperature
(50°C).
Make sure that the washing phase takes place correctly.
Unscrew the nozzles (22 Fig. 6) and clean them under
running water.
Contact the after-sales service.
Wait until the pressure returns or purchase a pressure pump.
Contact the after-sales service.
Make sure that the nozzles are in their correct positions.
Replace any damaged ones.