HOW TO POLISH FLOORS
Polish floors to give a hard, long-lasting shiny
finish. Attach brushes to polisher and guide
polisher in straight lines or with the grain of
the wood.
If more than one coat of wax is used, let dry
and polish a.fter each application.
HOW TO KEEP FLOORS BRIGHT AND
SHINY
Floors should be polished frequently with the polisher to
restore sheen and remove scratches and marks. This
lengthens the time between waxings. Before polishing, use
a vacuum cleaner to remove dust and dirt and a damp
sponge or mop to remove sticky food particles. Stubborn
spots, such as black heel marks, can be removed by rubbing
gently with fine steel wool dampe’ned with wax. For added
luster, snap on buffing pads* and buff floor.
If traffic areas need to be rewaxed and polished, and
Hoover wax or solvent-base wax has been used on the floor,
apply wax only to. these areas - then buff the entire floor.
Some brands of water emulsion wax should be removed by
scrubbing the entire floor when traffic areas show wear.
Additional applications cause a “build-up” of wax and
may cause floor discoloration.
* See page 9.
HOW TO POLISH FURNITURE
Lambs’ wool pads, which are available at your Hoover
Dealer’s store, are snapped on over the polishing brushes
to polish table tops, desks and counters. Use paste wax
on furniture. A very thin coat should be applied with a
dampened cloth. Let dry
20-30
minutes-then polish.
CAN WE HELP YOU?
If you have questions about home
care problems, we would like to hear from you. Please
write to :
THE HOOVER HOME INSTITUTE
THE HOOVER COMPANY
NORTH CANTON,
OHIO
7
To Next Page
Loading...
