CARE AND STORAGE OF YOUR POLISHER
Your polisher will require very little maintenance as the
power unit is sealed inside the head and is not subject to
damage by dirt or wax.
The polisher furniture guard and splash guard should be
wiped with a dry cleaning fluid or liquid soap after each
use to remove wax and dirt.
Remove brushes and dry inside of polisher head with paper
,
towel or c1ot.h before storing polisher.
Brushes need periodic washing in warm water and syn-
thetic detergent to remove excess wax. Rinse well. Let dry
before reattaching to polisher. The brushes on your Hoover
Polisher have plastic backs. They may be washed or soaked
in warm water without danger of warping.
Felt pads and lambs’ wool pads* should be washed occa-
sionally to remove wax.
If your polisher does not glide
easily when buffing floors, it may be due to an accumula-
tion of wax on the p,ads. Pads should be washed the same
way as brushes. Place on flat surface and smooth back
into shape. Do not stretch. Shake lambs’ wool pads several
times while drying to restore fluffiness. Let pads dry thor-
oughly before using. They will be damaged if used while
damp. Be sure that both the pads and the floor are dry
before buffing.
Wash Cleaning-Waxing pads* in warm water and synthetic
detergent. Rinse well. Then shake water
from pads and-let dry. These pads need
not be thoroughly dry when used.
Store the polisher in a cleaning closet or
convenient place, ready for use. Hang it
on wall, stand it on front bumper, or re-
move brushes.
Never store it on the brushes.
* Accessory (See page 9.)
8
To Next Page
Loading...
