6
1-20
1-21
1-22
1-19
U
T
E
C
B
A
Align opening (U) in filter bag with dirt
tube (T) inside bag compartment.
Push bag collar firmly onto dirt tube.
Tuck top and bottom of bag into bag
compartment.
To replace bag door, insert the tabs (V)
on bottom of bag door into the slots on
bag compartment.
Make sure all edges of paper bag are
completely inside the bag compartment.
Close door.
Break off red tab (E) above ON-OFF
switch by pushing down on tab.
Note: If tab has come off during assem-
bly make sure switch is in the OFF posi-
tion (down) before plugging cord into an
electrical outlet.
Stretch hose over tool rack and insert
hose connector into front of rack.
1-23
1-24
1-25
1-26
Attach hose and
tools
With cleaner in upright position, push
round end of hose firmly into “cup” on
back of rack.
Position wand in side of tool rack and
snap into place.
Snap dusting brush (A), crevice tool (B)
and furniture nozzle (C) into back of tool
rack as shown.
CAUTION: When cleaner is turned on,
the agitator brush roll will continue to
rotate while cleaner handle is in
upright position. Avoid tipping cleaner
or setting it on furniture, fringed area
rugs or carpeted stairs during tool
use.
Attach filter bag
V
To Next Page
Loading...
Need help?
General
