Hoover FoldAway - Final filter; Cleaning final filter; Headlight replacement; What to buy

Although not necessary, the filter can be
removed from the lid for cleaning.
Pull filter off lid and tap bottom of filter.
To replace, firmly press filter onto lid until
it stops.
Replace lid and filter on filter chamber.
Replace chamber on dirt cup.
Place bottom of cup behind tab (H) and
press cup into cleaner.
Rotate dirt cup handle (E) up to lock cup
in place.
Final filter
Cleaning final filter
The final filter assists in returning clean
air to the room.
Remove dirt cup.
Press latch (J) and remove filter grid.
Lift out filter (K) and hand wash in cold
water with a mild detergent.
Let filter air dry then reposition. Replace
filter grid and dirt cup.
Should you want to replace this filter, ask
for HOOVER part no. 38766008.
Do not operate cleaner without any of
the filters in place.
Headlight replacement
What to buy
This cleaner uses a 12 volt, wedge base
type 912 bulb, HOOVER part No.
27313107.
_5J_1
Disconnect cleaner from electrical
outlet.
Remove dirt cup as described in Fig.
3-2.
Insert a flat screwdriver into slot and
remove the access door (L).
Pull old bulb straight out of socket.
Push new bulb straight into socket until
locked in place.
Excessive force is not required.
\
Snap access door into place.
Reposition dirt cup (Fig. 3-10).