EN-13
In case of a power interruption while "H" is on, please pay attention to not touch
the cooking surface even if "H" is no longer shown when the power is back
‘H’ will show which cooking zone is hot to touch. It will disappear when the
surface has cooled down to a safe temperature. It can also be used as an
energy saving function if you want to heat further pans, use the hotplate that
is still hot.
.
Using the Power Management
Setting the total power level to fit your requiremen
Using power management you can set the total power to 2.5kW/ 3.0kW/ 4.5kW/
6.5kW and 7.4kW. The default total power setting is the maximum power level.
t
1. Make sure the cooktop is turned off.
Note: you can only set power management when the cooktop is turned off.
2. Touch the button “Pause function” and hold for 5 seconds.
You can hear the buzzer beeps one time.
3. After you hear the beep, touch “+” and
“-” button at the same
time and hold for 3 second, the timer indicator will show flashing previous total
power level, e.g. ‘2.5’. Touch and hold ” +” and ”-” for 1 second again to switch to
other power level, for example 3.0. When the power that you want is flashing,
touch the button “Pause function” and hold for 5 seconds. The buzzer will beep 10
times. It means you have finished the setting.
Note:
1. After step 2, you must touch the “+” and “-” within 3 seconds after you hear
the beep. Otherwise you will need to start again from step 2.
2. Once finish setting, wait till the end of 10 beeps. Do not touch any button during
this period. Otherwise the setting will be invalid.
14
s
Power Managemen
If total power exceeds the limitation of 2.5kw, 3.0kw, 4.5kw, 6.5kw,7.4kw
(depending on which level you’ve set), you are not able to increase power stage
of any zone.
If you increase it, the cooktop will beep 3 times and indicator will show a flashing
‘Pn’. Thus you need to decrease power stage of other zones before increasing the
power of objective zone.
t
• Cooking zones are divided into two groups. Each group has a maximum
electricity loading of 3600 W.
• The
heat setting display of the reduced zones changes between two levels
• The limitation decreases the power to the other cooking zones in the same group.
.
In Group a, both two zones can work at level 9 at the same time because they
are 3500 W in total.
In Group b if 3 zones are working, the max power level which each zone can
reach is 7. If you want one of the zone of Group b works at the highest power
level, only 2 zones can be turned on at most. The power level of first hob will
reduces automati
cally when reach power limitation.
To Next Page
Loading...
Need help?
General
