Hoover HMC5 User Manual

2
GETTING TO KNOW YOUR MATTRESS CLEANER
USING YOUR MATTRESS CLEANER
Make sure all the components are correctly assembled, take the power cord and plug into the power supply [1].
Press On/O button [2], the mattress cleaner will turn on and all 4 functions will automatically activate: Beat&roll, Vacuum, UV
light and Drying.
1. Beat&roll: The motorised agitator beats the mattress, penetrating deep into the bres helping to remove embedded dust mites
and allergens.
2. Vacuum: Thanks to its powerful suction, exposure to house dust mites, and allergens is reduced.
3. UV light: The UV light can help to reduce bacteria and keep your mattress fresher.
4. Drying: The use of 50°C hot air helps to dry the mattress to prevent the spread and growth of mould spores.
When the product is on the LED display shows: the humidity level detected [B1], status of the UV light [B2], dust sensor [B3] and
drying feature [B4]. The two colour dust sensor LED [B3] turns red when dust is detected and green when the area is clean.
WARNING: In order to avoid accident injury, the uv light will only work when the appliance is put on the working plate. The Light
Safety Switch Wheels underneath the product make the UV light turn it o automatically when the product has been lifted to avoid
any injury.
At any time during use, press the On/O Button to switch the appliance o.
MATTRESS CLEANER MAINTENANCE
Dust Cup Cleaning
Turn o the appliance [5], remove the plug from the power supply, press the dust cup release button and remove the dust cup
assembly [6]. Pull out the vortex Finder from the Dust Cup. Empty the contents of the dust cup and clean [7]. Remove the Pre-
motor lter, pre-motor Filter Foam, Vortex Finder Frame, Vortex Finder Mesh and Vortex Finder Seal. Wash with hand warm water
and allow to dry thoroughly before replacing in the appliance [8]. Rinse and wipe clean any dust build up on the Vortex nder
Mesh [I]. After cleaning, reassemble the vortex nder together with the Dust cup, then ret the Dust cup assembly onto the main
body.
Cleaning the Washable Filters (Pre-motor lter and foam)
To maintain optimum cleaning performance regularly remove the lters and tap against the side of the bin to release
dust. The lters should be washed under hand warm water when they have excessive dust level. Do not use hot water or
detergent [8].
IMPORTANT: All bagless cleaners require regular lters cleaning. Failure to clean your lters may result in air blockage,
overheating and product failure. This may invalidate your guarantee.
IMPORTANT: Always ensure the lters are fully dry before use. Do not use the product without the lters tted.
A. On/O Button
B. LED Display
B1. Humidity Indicator
B2. UV Light Indicator
B3. Mite / Dust Sensor Indicator
B4. Drying function indicator
C. Dust Cup Assembly
D. Dust Cup Release Button
E. Vortex Finder
F. Pre-motor Filter
G. Pre-motor Filter Foam
H. Vortex Finder frame
I. Vortex Finder Mesh
J. Vortex Finder Seal
K. Dust Cup
L. Power Cord
L1. Velcro Strap
M. Air Vent
N. UV Light
O. UV Light Safety Switch Wheels
P. Agitator Cover Plate
P1, P2, P3. Locking Clips
Q. Agitator
R. Belt
GB

Hoover HMC5 Specifications

General

Brand	Hoover
Model	HMC5
Category	Vacuum Cleaner
Language	English