In order to extend the life of your appliance, you should rinse the boiler to avoid
scale deposit in the boiler. You should rinse it every 2 months on models SFD 4102
and SRD 4107.
For models SRD 4108, SRD 4110 and SRP 4105 wait for the “rinse” light (1e) ashes.
Models with “Rinse” Light
Only remember to clean the boiler before use next time you plan to iron. Proceed as
followed:
Before going on, be sure that the appliance is cooled down and unplugged for at
least 2 hours.
the calc removal cap (10). Unscrew the boiler rinse safety cap anti-clockwise with
a coin and remove it. Fill the boiler with 0,2 litres of tap water using a bottle and a
in the sink. We recommend repeating this operation twice. Screw the boiler rinse
safety cap with a coin and put back the calc removal cap (10).
Next time you will plug and switch on your appliance, the rinse light (1e) will
start your ironing session immediately.
Models Without “Rinse” Light
Before proceeding, be sure that the appliance is cooled down and unplugged for at
least 2 hours.
the calc removal cap (17). Unscrew the boiler rinse safety cap anti-clockwise with
a coin and remove it. Fill the boiler with 0,2 litres of tap water using a bottle and a
in the sink. We recommend repeating this operation twice. Screw the boiler rinse
safety cap with a coin and put back the calc removal cap (17).
In any case, do not use any descaling products to clean or rinse the boiler.
Fig. 11: Cleaning Operation
Chapter 4.2 - Rinsing the Boiler for Scale Maintenance
Ironspeeed_SR__1-15_union_pprod3.indd 12 11-12-2009 9:59:58
To Next Page
Loading...
Need help?
General
