Hoover Savvy - Troubleshooting and Service; Lubrication and Thermal Protector; Common Problems and Solutions

The cleaner is equipped with bearings
that contain sufficient lubrication for the
life of the cleaner. The addition of lubri-
cant could cause damage. Therefore,
do not add lubricant to any bearings.
Thermal pretecter
An internal thermal protector has been
designed into your cleaner to protect it
from overheating.
When the thermam protector activates,
the suction motor wHI stop running,
however the agitators will continue to
run. If this happens, proceed as follows:
1. Turn the cleaner OFF and discon-
nect it from the electrical outlet.
2. Check bag. Replace if full.
3. Check final filter for dirt accumula-
tion.
4. Refer to "Clearing blockages"
section.
5. When the motor cooms, the thermal
protector automatically resets and
cleaning may continue.
If the thermal protector continues to
activate after following the above steps,
your cleaner may need servicing (see
'Service" section).
Heever Cleaning
This Hoover Cleaning Performance Sys-
tem is for comparing the relative pro-
gressive performance of Hoover
uprights only and not for comparison
with any other brands. The majority of
this rating is based upon the ASTM
International Carpet Cleaning Effective-
ness Test (ASTM Test F608). Other per-
formance factors include Hose Power
(ASTM Test F558), Surface Litter Clean-
ing, Hard Floor Cleaning, Edge Clean-
ing, Cleaning Width, and Air Filtration.
If a minor problem occurs, it usually can
be solved quite easily when the cause is
found the check list below.
Possible cause
Possible solution
• Not firmly plugged in
• Plug unit in firmly
• No voltage in wall plug
• Check fuse or breaker
• Blown fuse or tripped breaker
• Replace fuse or reset breaker
• Thermal protector activated
• Allow cleaner to cool (this will reset the
thermal protector) (see pg. 10).
• Brush roll shut-off tripped
• Turn cleaner OFF, clear brush rolls.
Turn cleaner back ON. Prob
Possible cause
Possible solution
• Custom Control TM switch set on
BARE FLOOR position,
• Set switch to carpet position.
• Agitators are obstructed.
• Clear obstruction.
Possible cause
Possible solution
• Thermal protector activated
• Allow cleaner to cool (this will reset the
thermal protector) (see pg. 10).
• Filter bag full
• Change filter bag.
• Incorrect carpet height setting
• Move nozzle control knob to lower
setting.
Possible cause
Possible solution
• Incorrect carpet height setting
• Move nozzle control knob to a
higher setting
Possible cause
Possible solution
• Too much pressure being applied to
tool
• Continue using tool applying light
pressure.
• Blockage in turbine channel
• Remove blockage.
• Broken or worn belt
• Replace belt
• Low cleaner suction
• Check items under "Cleaner won't pick
up".
Possible cause
Possible solution
• Blockage in hose
• Clear blockage.
• Thermal protector activated
• Allow cleaner to cool (this will reset the
thermal protector) (see page 10.)
10