To Next PageTo Next PageWhy my Hoover T UH70110 won't turn on?
First, ensure the power cord is firmly plugged into the outlet. If the vacuum still doesn’t run, check your home's fuse or breaker. Replace the fuse or reset the breaker if needed. Finally, if the thermal protector has activated, unplug the Hoover Vacuum Cleaner and allow it to cool for 30 minutes to reset it.
What to do if my Hoover Vacuum Cleaner has low suction?
If the System Check Indicator on your Hoover Vacuum Cleaner has turned red, or if you're experiencing low suction, several factors could be the cause. Start by checking if the rinsable filter or HEPA media filter is dirty and clean it. Also, empty the dirt cup if it's full or clogged. A broken or worn belt can also cause suction issues, so replace it if necessary. Make sure that the brushroll and hose are free from clogs. Ensure the carpet height setting is correct for your carpet type. Lastly, verify that the Suction Only Mode is turned off.
Why is dust escaping from my Hoover T UH70110 Vacuum Cleaner?
Dust escaping from your Hoover Vacuum Cleaner can be due to several reasons. Check if the dirt cup is full and empty it if necessary. Ensure the dirt cup and hose are installed correctly. Also, make sure the rinsable filter and/or the filter made with HEPA media are completely installed.
How to fix a Hoover Vacuum Cleaner that is hard to push?
If your Hoover Vacuum Cleaner is difficult to push, the carpet height setting may be incorrect. Adjust the Carpet Height Adjustment knob to the appropriate setting for the carpet you are cleaning.
What to do if the brushroll on my Hoover T UH70110 Vacuum Cleaner powered hand tool won’t turn?
If the powered hand tool brushroll on your Hoover Vacuum Cleaner won’t turn, it could be due to a few reasons. You might be applying too much pressure, so try using the tool with light pressure. There could also be a blockage, so remove any obstructions. Low vacuum suction can also cause this issue; check the troubleshooting steps for 'Vacuum won’t pick or Low suction'.
Why does my Hoover T UH70110 have a burning smell?
A smoky or burning smell from your Hoover Vacuum Cleaner could indicate a broken or stretched belt, so replace the brushroll belt. Alternatively, the brushroll might be clogged. Clear any debris from the brushroll.
General| Type | Upright |
|---|---|
| Weight | 16.5 lbs |
| Filtration | HEPA |
| Cord Length | 27 ft |
| Power | 12 amps |
| Bagged or Bagless | Bagless |
