DO NOT USE CLEANER OUTDOORS
or ON DAMP or WET SURFACES.
POWER button
OThe POWER button (A) is located
atthe top of the cleaner body.
Plug cord into electrical outlet.
Toturn cleaner ON, pressbutton once.
Toturn cleaner OFF, pressbutton again.
NOTE: THE CLEANER IS SHIPPED
WITH THE CONTROL DIAL IN HARD
FLOOR POSITION. BEFORE YOU
BEGIN TO CLEAN CARPETS, ROTATE
THE CONTROL DIAL FROM HARD
FLOOR TO A CARPET SETTING.
Surface Command TM
control dial (some models)
The Surface CommandTM control
(some models) isan automat-
ic height adjustment that allows you to
choose a cleaning mode for carpet
height or hard surfacefloors.
For maximum cleaning performance,
the following carpet height settingsare
recommended:
Lowestsetting: for all types of carpet,
Note: If the cleaner is difficult to push,
turn dial to the next higher setting.
Higher settings: for very deep pile car-
pet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
HARD FLOOR The agitator brush roll is
OFF;the nozzle is set at LOW.
Surface Selector (some
models)
Q The SurfaceSelector (some
models) hasthree carpet height
settingsand a hard floor setting. The
SurfaceSelector turns to allow you to
choose a cleaning mode for carpet
height or hard surfacefloors.
Formaximum cleaning performance, the
following carpet height settingsare rec-
ommended:
Lowestsetting: for all types of carpet,
Note: If the cleaner is difficult to push,
turn dial to the next higher setting.
Higher settings: for very deep pile car-
pet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
HARD FLOOR MODE (with agitator
brush roll shut oft0the nozzle is set at
LOW,
Automatic agitator
brush roll shut-off
_lhThe agitator brush roll will turn off
_llmF when the handle is in the upright,
storageposition.
Agitator brush roll control
OR
HiGH
_ otate control dial to "Carpet"
settings (A)to turn agitator brush
roll ON for cleaning carpet or rugs.
Rotatecontrol dial to "Hard Floor" (B)to
turn agitator brush roll OFF when clean-
ing hard floors.
Cord rewind
\\
Q raspthe end of the plug and
pull to release cord from cord
reel.After desired cord length is reached,
the cord will lock into position.
(Cont'd) -_ 07