Horizon Hobby E-flite Eratix 3D Flat Foamy 860mm User Manual (English)

Questions and Answers:

T
Tiffany ForbesJul 29, 2025
Why is my Horizon Hobby E-flite Eratix 3D Flat Foamy 860mm oscillating?
- C
  Chris BrownJul 29, 2025
  If your Horizon Hobby Toy exhibits oscillation, it could be due to several factors. A damaged or imbalanced propeller can cause this, so replace or balance the propeller. Motor vibration can also be a culprit; consider replacing parts or aligning and tightening fasteners. Additionally, a loose receiver or aircraft controls can contribute to oscillation; secure the receiver in the fuselage and tighten the aircraft controls. Worn parts, especially the propeller or servo, may need replacement. Finally, irregular servo movement can cause oscillation, so consider replacing the servo.
P
Patrick GoldenAug 8, 2025
What to do if my Horizon Hobby E-flite Eratix 3D Flat Foamy 860mm Toy has inconsistent flight performance?
- P
  ptaylorAug 8, 2025
  If your Horizon Hobby Toy's flight performance is inconsistent, ensure the trim is at neutral. If you adjust the trim more than 8 clicks, adjust the clevis to remove trim. Also, ensure that Sub-Trim is not active; adjust the servo linkage instead. Finally, the aircraft must remain immobile for 5 seconds after battery connection. Disconnect and reconnect the battery with the throttle stick in the lowest position, keeping the aircraft still for 5 seconds.
V
Victoria BrownAug 17, 2025
What to do if Horizon Hobby E-flite Eratix 3D Flat Foamy 860mm has incorrect response to the AS3X Control Response Test?
- V
  Vicki CraneAug 18, 2025
  If your Horizon Hobby Toy shows an incorrect response to the AS3X Control Response Test, do not fly it. This indicates incorrect direction settings in the receiver, which could lead to a crash. Correct the direction settings by referring to the receiver manual before attempting to fly.