Hörmann FCT 10 - General; Installation; Important terminology; Putting into operation and Changing the Battery

To Next Page

To Previous Page

09.2006 TR20A002-A RE

1 General

2 Installation

3 Important terminology

4 Putting into operation / Changing the battery

5 Normal Operation

5.1 Programming Functions

5.1.1 Altering the IB code or entering a personal IB code

5.1.2 Entering or altering the access codes

5.1.3 Deleting the access codes

5.2 Operating functions

5.2.1 Transmitting after entering an access code

5.2.2 Learning after entering an access code

5.2.3 Recoding a radio code location with an access code or

resetting this radio code location to the factory coding

5.3 Direct function of the "bell/light" key

5.3.1 Transmitting using the "bell/light" key

5.3.2 Learning using the "bell/light" key

5.3.3 Recoding the radio code location of the "bell/light" key or

resetting this radio code location to the factory coding

6 EU Manufacturer's Declaration

1 General

The FCT 10 Code Modulator is a combination of a hand transmitter and a

digital coder and apart from the receivers which for the main part are already

available does not require any additional equipment.

ENGLISH