To Next PageTo Next Page
Need help?Do you have a question about the HORNER HE959CNX116 and is the answer not in the manual?
General| Brand | HORNER |
|---|---|
| Model | HE959CNX116 |
| Category | Conference System |
| Language | English |
Specifies the steady state and inrush power requirements for the module.
Defines the acceptable voltage range for the module's primary power supply.
Details the number of flexible inputs, configurable as digital or analog.
Specifies the number and characteristics of the module's digital outputs.
Details the number and type of analog inputs supported by the module.
Specifies the number and type of analog outputs provided by the module.
Covers operating and storage temperature, and relative humidity limits.
Identifies the supported CAN communication protocols.
Lists the available input voltage and current ranges for universal analog inputs.
Specifies the analog-to-digital converter type and resolution.
Describes the output type, including sourcing and pull-down configuration.
Details the protection features for the digital outputs, such as short circuit protection.
Specifies the OFF to ON and ON to OFF response times for digital outputs.
Lists the available data ranges for analog outputs (voltage and current).
Specifies the resolution of the analog output conversion.
Details configuration options when inputs are set as Analog I/O.
Details configuration options when inputs are set as Digital Inputs.
Describes how to mount I/O modules onto a DIN-rail.
Information on adding or removing modules while the system is powered.
Important warnings regarding equipment use, explosion hazards, and component substitution.
Guidelines for connecting outputs to appropriate voltage levels and power sources.
Provides contact details for technical assistance and manual updates in North America and Europe.
Details the pin assignments for the CAN interface, including signal names and descriptions.
Guidance on powering the OCS-I/O HE959CNX16 Base independently from modules.
Recommendations for network wiring, including daisy-chaining, shield connections, and termination resistors.
Diagrams and labels for onboard wiring connections, including CAN ports and I/O.
Step-by-step guide for configuring the OCS-I/O base and modules using Cscape software.
Details on configuring individual I/O modules, including input/output mapping and communication timeouts.
Provides a layout of status registers and their corresponding bits for I/O modules.
Explains the meaning of individual bits within the status registers (e.g., CME, IOE, WDG TRIP).
Defines the alarm states (Low-Low, Low, Normal, High, High-High) based on alarm bits.
Describes the status of system-level LEDs (Power, Self-Test, Network, Configuration).
Explains the meaning of LEDs for individual I/O channels (Digital Inputs/Outputs, Analog Inputs/Outputs).
