HORSCH, LLC
200 Knutson St. Mapleton, ND 58059 (T) 701-532-1000 (F) 701.532-1101 (E) info.us@horsch.com PN 05951465
Common Issues / Troubleshooting:
Machine is burying itself.
It was commanded to go down after it
was already down.
Machine is stuck down and will not
come back up.
Verify timer setting on down
mode.
Pick machine
and wait for the num
bers on
the control panel to quit
flashing.
Press for it t
when it moves pull back on the
remote to go up and wait for
the lights to quit flashing.
Machine is ridging on one
side.
Case Drain circuit plugged in to wrong
remote.
Connect Case Drain circuit to
correct remote.
Machine is slow to raise and
lower.
Tractor SCV not set to 100%.
O-ring in load cartridges damaged.
Replace damaged O-ring.
desired depth.
Cylinders not reaching set points
before hydraulic flow stops.
Adjust SCV timer setting so
valve returns to neutral within 5
movement stopping.
Machine acts erratically, does
not maintain consistent depth.
Drain line is not connected or SCV is
not in float. SCV lever is being
operated multiple times per lift/lower
cycle.
Check drain line and verify
SCV is in float. SCV lever
position does not always
correctly indicate valve
position. Refer to tractor
operator manual for correct
operation of SCV functions.
Machine stops then continues
past desired set depth.
SCV is still active after all cylinder
movement has stopped.
Reduce timer setting (if used).
Return SCV to neutral within 5
seconds of all cylinders
stopping.
To Previous Page
Loading...
