EasyManuals Logo

Hoshizaki DCM-270BAH Cleaning & Sanitizing

Hoshizaki DCM-270BAH
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Cleaning Prep:
Close the water supply line shut-off valve
and
dispense all the ice from the storage bin.
Move the power switch to OFF. Remove the Louver
& Air Filter. Move the control switch to DRAIN.
Move the power switch to ON. Allow the icemaker to drain
completely. Move the power switch to OFF.
ATTENTION! WAIT 1 MINUTE AFTER POWERING OFF,
to allow control board to de-energize. Otherwise there will
be a long delay before ICE or DRAIN will activate.
Cleaning:
Unplug the icemaker from the electrical outlet. Dilute Hoshizaki Scale
Away with warm water (see Table below). Remove the Front Panel*,
Top Panel, Bin Top, Agitator, Drip Ring, Grille, and Spouts A & B**.
Pour cleaning solution over the Extruding Head until
the Evaporator Assembly and the Reservoir are full
and the solution overflows into the Drain Pan. Allow
to soak for 10 minutes.
*Push-button models: Take care in disconnecting the button connector.
**Use a 15mm socket with an extension to easily remove recessed thumb screws.
In bad water conditions, a more thorough soaking may be
required. Follow Step , then place a clamp on the
Reservoir hose that will block the flow to the evaporator
assembly. Pour additional cleaning solution over the
Extruding Head until the Evaporator Assembly is full.
Allow to soak. Otherwise, continue to Step .
DCM-270BAH(-OS)
Scale Away
6 fl. oz (177 ml)
Warm Water
1 gal. (3.8 l)
Reservoir Hose
Control Switch
Power Switch
Left Side
View
Ice Machine
Sanitizing:
Dilute 5.25% chlorine
bleach
with warm water
(see Table below)
DCM-270BAH(-OS)
Bleach
1.5 fl. oz (44 ml)
Warm Water
3 gal. (11.4 l)
Use bleach without additives.
Pour the sanitizing solution
over the extruding head until
solution starts to overflow
into the drain pan
Allow to soak for 10 minutes
Scrub all items with a nylon
scouring pan, brushes, and
sanitizing solution
Rinse all items thoroughly
with clean water
Move control switch to ICE,
replace the front panel
Reassemble drip ring, agitator,
bin top, grille, spouts A & B,
and replace panels
Plug in the icemaker
Move the power switch to ON
Make ice with the solution until
it stops, dispose of ice
Move the power switch to
OFF
Unplug the icemaker
Allow
to
drain
Cleaning & Sanitizing
AMMONIA
Cleaners
The icemaker/dispenser must be cleaned & sanitized at least twice a year.
continued on the back…
ATTENTION!
Do not leave icemaker
unattended when panels are off
Tech Support: 1.800.233.1940
1
2
3
4
15
16
17
18
19
5
20
#51050 | 10.06.2016
Page 1
Top
Right Side
Front of
icemaker
(-OS) models
If switch is left on DRAIN for more than 10 min., a 2-beep alarm will sound every 5 seconds.
Wait
1 min.
Unplug
To Icemaker
Or Water Filter
SHUT OFF
REMOVE ICE
CLEAN
Storage
Bin

Other manuals for Hoshizaki DCM-270BAH

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hoshizaki DCM-270BAH and is the answer not in the manual?

Hoshizaki DCM-270BAH Specifications

General IconGeneral
BrandHoshizaki
ModelDCM-270BAH
CategoryIce Maker
LanguageEnglish

Related product manuals