Do you have a question about the Hoshizaki KM-900MRH and is the answer not in the manual?
Technical specifications for the KM-900MAH air-cooled model.
Specifications for KM-900MWH water-cooled model, serial range L00001D-M20500D.
Specifications for KM-900MWH water-cooled model, serial range M30501D--.
Technical specifications for the KM-900MRH remote air-cooled model.
Specifications for KM-900MRH3 remote air-cooled 3 phase model.
Detailed specifications for the URC-12F condensing unit.
Details the construction of KM-900MAH, KM-900MWH, KM-900MRH, KM-900MRH3 models.
Explains the controller board, its features, safeties, and sequence operations.
Covers operation and troubleshooting for the mechanical bin control.
Illustrates water and refrigerant circuits for KM-900MAH, KM-900MWH, KM-900MRH/MRH3.
Electrical wiring diagrams for KM-900MAH, KM-900MWH, KM-900MRH, KM-900MRH3.
Visual timing chart for various icemaker cycles and component operations.
Identifies causes and remedies for the icemaker producing no ice.
Addresses problems related to the evaporator freezing up during operation.
Explains causes and solutions for reduced ice production rates.
Covers issues like small or cloudy ice cubes and their causes.
Discusses problems like the icemaker not stopping or abnormal noises.
Procedures for handling refrigerant lines, recovery, evacuation, recharge, and brazing.
Step-by-step guide for replacing the icemaker compressor unit.
Instructions for removing and replacing the filter drier and expansion valve.
Procedures for removing and replacing hot gas and line valves.
Detailed steps for removing and installing the icemaker evaporator.
Steps for removing, replacing, and adjusting the water regulating valve.
Guide for safely removing and installing the thermistor component.
Instructions for replacing the fan motor assembly.
Procedures for replacing the water valve and pump motor.
Steps for removing and installing the icemaker spray tubes.
Instructions for properly preparing the icemaker for extended periods of non-use.
Detailed steps for cleaning and sanitizing the icemaker components.
Routine maintenance for the icemaker's exterior, bin, and condenser.