EasyManua.ls Logo

Hotpoint HS2321L - Troubleshooting

Hotpoint HS2321L
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB
7
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24
Troubleshooting
If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list.
Malfunctions:
The internal light does not illuminate.
The refrigerator do not cool well.
The food inside the refrigerator is
beginning to freeze.
The motor runs continuously.
The appliance makes a lot of noise.
The alarm sounds and the lamp
flashes.
The alarm sounds and the set
temperature indicator lights flash
(allofthemexcludingtheSuperCool
indicator light which is turned off).
The back wall of the refrigerator unit
is covered in frost or droplets of
water.
There is water at the bottom of the
refrigerator.
Possible causes / Solutions:
• Theplughasnotbeeninsertedintotheelectricalsocket,ornotfar
enough to make contact, or there is no power in the house.
• Thedoordonotcloseproperlyorthesealsaredamaged.
• Thedoorareopenedtoofrequently.
• ThesetTEMPERATUREindicatorlightisdisplayinganincorrectreading.
• Therefrigeratorhavebeenover-filled.
• ThesetTEMPERATUREindicatorlightisdisplayinganincorrectreading.
• Thefoodisincontactwiththebackinsidewalloftherefrigerator.
• Thedoorisnotclosedproperlyoriscontinuouslyopened.
• Theoutsideambienttemperatureisveryhigh.
• Theappliancehasnotbeeninstalledonalevelsurface(seeInstallation).
• Theappliancehasbeeninstalledbetweencabinetsthatvibrateandmake
noise.
•Theinternalrefrigerantmakesaslightnoiseevenwhenthecompressoris
off. This is not a defect, it is normal.
•Therefrigeratordoorhasbeenopenformorethan2minutes.Thebuzzer
will stop sounding when the door is shut.
•Theappliancesignalsthatithasheatedexcessively.Werecommend
checking the state of the foodstuffs: they may need to be removed. In this
situation, the product continues functioning as in the normal functioning
mode.Thebuzzercanbestoppedbysimplyopeningandclosingthe
door. To stop the indicator lights from flashing, it is necessary to turn
off the appliance using the adjustment button (OFF), then use the same
button to switch on the appliance and restore normal functioning at the
desired temperature.
•Thisshowstheapplianceisoperatingnormally.
• Thewaterdischargeholeisblocked(seeMaintenance).

Other manuals for Hotpoint HS2321L

Related product manuals