Hotpoint WM12 - Page 7

Getting to know your Machine
PROGRAMMING
Label codes Temp
New Old 2G
\g5/ (E 95
\s0/ ial 60
\50/ \ā 50
\40/ 3 40
40 (a 40
\40/ Z 40
ADDITIONAL PROGRAMMES
PREWASH
QUICK WASH
SPIN
OTHER SYMBOLS
END OF PROGRAMME
© ®
~.
rP
©) yy
a a O l ba S,
LONG SPIN SHORT SPIN
oe
M
LL
RINSES
To select a programme turn the selector knob clockwise until
the required programme symbol is at the 12 o’clock position.
The symbols on the dial correspond to the international wash
care symbols, which you will find on your clothing. These
indicate the recommended wash required for that fabric eg:
Fabric Max Load
kg (Ib)
White cotton and linen without special 5 (11)
finishes.
Colourfast cotton, linen or viscose 5 (11)
without special finishes.
Coloured Nylon Polyester 3 (6.5)
Acrylic/cotton mixtures cotton or
viscose without special finishes (eg
drio-dry), coloured Polyester/cotton
mixtures.
Non-colourfast cotton, linen and 5 (11)
viSCose.
Acrylics, acetates & tri-acetates 3 (6.5)
blends of these fabrics with wool,
and polyester/wool blends.
Woollen blankets, wool mixtures with 2.7 (6)
cotton or rayon, silk.
Shrink-resistant machine washable 1.4 (3)
and superwash woolmark garments.
The following may be selected if required...
Select prewash for really dirty clothes. Prewash heats water to
a temperature of 40°C.
When the prewash is complete the programme selector will
stop at the symbol ®@. You should then switch the appliance
off, turn the knob to the required main wash and switch on.
DO NOT Use for woollens or machine washable wool.
A quick cool wash,without heating the water, to freshen up
lightly soiled items in about 30-35 minutes. Maximum load
0.9kg (2lb).
DO NOT Use for woollens or machine washable wool.
Long spin for robust fabrics........ Short spin for delicate fabrics.
DO NOT fill more than half full with wet clothes. At the end of
the spin cycle, there will be a few short tumbles before the
programme finally finishes.
For a rinse or a rinse and spin programme. Depending on the
type of fabric, select the correct rinses programme before the
spin that you require.
First dot will give most rinses and last cot least rinses.