Hotpoint WML 540 P User Manual

2
GB
Installation
!Keep this instruction manual in a safe place for future
reference. Should the appliance be sold, transferred or
moved, make sure the instruction manual accompanies the
washing machine to inform the new owner as to its opera-
tion and features.
!Read these instructions carefully: they contain vital
information on installation, use and safety.
Unpacking and levelling
Unpacking
!This is a separate part
of the polystyrene base
and should be removed
with the base.
!IMPORTANT check when
unpacking your machine.
1. Unpack the washing machine.
2. Check whether the washing machine has been dama-
ged during transport. If this is the case, do not install it
and contact your retailer.
3. Remove the 4 protecti-
ve screws and the rubber
bush with the respective
spacer, situated on the
rear of the appliance (see
also the installation leaflet).
4. Seal the gaps using the plastic plugs provided.
5. Keep all the parts: you will need them again if the
washing machine needs to be moved to another location.
!Packaging materials are not children’s toys.
Levelling
Your machine may make a
considerable amount of noise
if the two front feet have not
been adjusted correctly.
1. Install the washing ma-
chine on a flat sturdy floor,
without resting it up against
walls, furniture cabinets or
other.
2. If the floor is not perfectly level, compensate for any
unevenness by tightening or loosening the adjustable
front feet (see figure); the angle of inclination, measu-
red according to the worktop, must not exceed 2°.
Levelling your appliance correctly will provide it with
stability and avoid any vibrations, noise and shifting du-
ring operation. If it is placed on a fitted or loose carpet,
adjust the feet in such a way as to allow enough room
for ventilation beneath the washing machine.
Electric and water connections
Connecting the water inlet hose
1. Connect the supply pipe
by screwing it to a cold
water tap using a
3/4 gas threaded connec-
tion (see figure).
Before performing the
connection, allow the wa-
ter to run freely until it is
perfectly clear.
2. Connect the other end of
the water inlet hose to the
washing machine,
screwing it onto the ap-
pliance’s cold water inlet,
situated on the top right-
hand side on the rear of the
appliance (see figure).
3. Make sure there are no kinks or bends in the hose.
! The water pressure at the tap must be within the
values indicated in the Technical details table
(see page 5).
! If the water inlet hose is not long enough, contact a
specialist store or an authorised serviceman.
! Ensure that the supply taps are allowing water throu-
gh. Old taps may seize in the closed position and thus
prevent water reaching the machine.

Hotpoint WML 540 P Specifications

General

Water consumption per cycle	- L
Energy consumption washing per cycle	- kWh
Door hinge	Right
Display type	LED
Loading type	Front-load
Product color	White
Custom panel-ready	No
Appliance placement	Built-in
Washing class	A
Drum capacity	6 kg
Spin-drying class	B
Maximum spin speed	1400 RPM
Number of washing programs	4

Weight and Dimensions

Depth	565 mm
Width	595 mm
Height	850 mm