Enjoy peace of mind while the illuminated water care icon and system status
messages on the spa’s main control panel confirm that the ACE
®
system is keeping
your spa water clean and crystal clear.
Spa Owner Responsibilities
• Thoroughly reading & understanding the Spa Manual, Operation & Water
Quality sections.
• Balancing the pH level and Total Alkalinity to the “OK” range.
NOTE: The generation of chlorine from salt will cause the pH to drift upwards
over time. Check the pH level at least once a week after initial start-up, and
once a month after normal use patterns have been established. Adjust as
needed to maintain water quality. An extensively high pH will cause premature
failure of the system, cloudy water, and decreased effectiveness of the sanitizer.
• Maintaining a low Hardness level of 50 ppm by using the Vanishing Act calcium
remover as needed.
NOTE: The ACE system works best with low levels of calcium and minerals
in the water. Softened water prolongs the life of hot tub equipment, while
enhancing the soaking experience.
• Inputting Spa Size and Use Level.
• Checking chlorine level before each use to determine best Use Level to
maintain healthy water quality.
• Conducting a check up every 30 days, which includes testing and balancing the
spa water, and reconfirming Use Level.
NOTE: The 30-day cycle begins when the Use Level is confirmed at start-up,
and resets any time the Use Level is changed or re-confirmed. The water care
icon will flash as a reminder when each 30-day cycle is over.
• Establishing a 5 ppm chlorine residual at start up and monthly
flushing plumbing
lines by super-chlorinating or “shocking” the spa monthly.IMPORTANT: Ensure that
the chlorine level is always between 3-5ppm before using the spa. Add chlorine
manually if needed.
Before Start-Up
1. Fill your spa with water using the Clean Screen pre-filter.
NOTE: If you are not filling your spa for the first time, clean your filters with
FreshWater Filter Cleaner or replace with new filters, before refilling spa.
2. Once your spa is filled, use a FreshWater test strip to measure the pH, Total
Alkalinity, and Hardness. Use the table below to determine if your spa water is in
the “OK” range. The “OK” ranges listed below are specific for use with the ACE
salt water sanitizing system and may vary from the back of your test strip bottle.
Page 2 ACE Salt Water Sanitizing System
To Next Page
Loading...
Need help?
General
