13
Operations
Assembly Instructions
Unpacking
Unpack carefully. Wear safety glasses or goggles while
unpacking, assembling or operating pressure washer. If
there are missing components or hidden damage
immediately contact dealer or carrier concerning
discrepancies.
1. Cut strapping band from pressure washer and
pallet.
2. Remove pressure washer from pallet.
Parts Included
• Pressure Washer
• Pressure Hose
•Wand
• Parts Box Containing:
- Pressure Nozzles (3 ea.)
- Trigger Gun
• Operating Instructions and Parts Manual
Tools Required
• 10" Adjustable Crescent Wrenches (2 ea.)
• Blade Screwdriver
Pressure Hose, Wand and Wand Holder
1. Use teflon tape on plumbing connections to
prevent leakage.
2. Install pressure hose on machine as shown.
3. Assemble wand components as shown. Connect
pressure hose to trigger gun.
NOTE: The nozzle is not to be installed at this time.
NOTE: Pressure relief valve should be inspected
and tested annually.
4. Make sure that all plumbing connections are tight.
Note: Longer shroud at end of hose should be
connected to spray gun.
Wand
Quick Disconnect Plug
Hotsy 900/1400 Operator’s Manual 9.803-325.0 - C
Pressure Hose
Relief Valve
To Next Page
Loading...
