Hotsy 1835SS User Manual (English)

Other manuals for Hotsy 1835SS

Questions and Answers:

S
Sarah NicholsAug 8, 2025
What to do if my Hotsy 1835SS Pressure Washer runs but won't spray?
- R
  Richard SantosAug 9, 2025
  If your Hotsy pressure washer runs but won't spray, make sure you are squeezing the trigger of the trigger gun. Next, check that the water supply is turned on fully. Then, inspect the pressure nozzle for clogs and clean it if necessary. Also, check the inlet water screen for clogs and clean it if needed. Lastly, check for loose hose clamps or fittings and fill the detergent container to prevent the pump from sucking air.
L
laura84Aug 15, 2025
Why Hotsy Pressure Washer will not produce hot water?
- M
  Miss Alexandria Aguilar MDAug 15, 2025
  If your Hotsy pressure washer isn't producing hot water, first ensure the burner and gas valve switches are in the ON position. Check that you have an adequate fuel supply and that the manual gas valve is open. Also, verify that the pump switch is on, as the pump must be running before the burner will light. Ensure you have an adequate water supply by fully opening the faucet and checking for any kinks or damage to the hose. Squeeze the trigger, as water must be spraying for the burner to light. Finally, check the thermostat setting and replace it if defective. If the gas valve is defective, replace it.
L
Laurie DurhamAug 21, 2025
How to fix low spray pressure on Hotsy Pressure Washer?
- M
  michael07Aug 21, 2025
  If you're experiencing low spray pressure at the nozzle of your Hotsy pressure washer, first ensure you have an adequate water supply by fully opening the faucet and checking for any kinks or damage to the hose, using a 5/8" minimum hose. Also, check for debris clogging the inlet screen. Then, inspect the pressure nozzle for partial clogs or damage and clean or replace it as necessary. Finally, ensure that the detergent container is full and the pick-up screen is fully immersed to prevent air from being drawn through the detergent inlet line.
L
Lisa WatsonAug 27, 2025
Why my Hotsy Pressure Washer will not run?
- R
  Robert TerrellAug 27, 2025
  If your Hotsy pressure washer isn't running, first, ensure the pump switch is in the ON position. Then, check that the power supply is properly connected. Also, inspect the electrical supply line for a blown fuse or tripped circuit breaker and replace or reset it, ensuring you're using circuits with adequate capacity. Finally, if the motor circuit is overloaded, allow it to cool down before placing the pump switch in the ON position.
M
muelleremilySep 1, 2025
What causes uneven spray pattern on Hotsy 1835SS Pressure Washer?
- A
  Alicia CollinsSep 1, 2025
  If your Hotsy pressure washer has an uneven spray pattern, the most likely cause is a partially clogged or damaged pressure nozzle. Try cleaning the nozzle, and if that doesn't resolve the issue, replace it.