EasyManua.ls Logo

HouseWarmer HWDV080DVN-1 - User Manual

HouseWarmer HWDV080DVN-1
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DIRECT VENT
WALL FURNACE
STANDARD MODELS:
HWDV080DV(N,P)-1
HWDV181DV(N,P)-1
MODELS WITH BLOWER:
HWDV080BDV(N,P)-1
HWDV181BDV(N,P)-1
This appliance may be installed in an after-
market, permanently located, manufactured
home (USA only), or mobile home, where not
prohibited by state or local codes.
This appliance is only for use with the type of
gas indicated on the rating plate. This appliance
is not convertible for use with other gases.
INSTALLATION
INSTRUCTIONS AND
OWNER'S MANUAL
WARNING: If not installed, operated, and
maintained in accordance with the manufactur-
er's instructions, this product could expose you
to substances in fuel or from fuel combustion
which can cause death or serious illness.
Installer: Leave this manual with the ap-
pliance.
Consumer: Retain this manual for future
reference.
Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do
not use any phone in your building.
Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
If you cannot reach your gas supplier,
call the fire department.
Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
WARNING: If the information in these in-
structions are not followed exactly, a fire
or explosion may result causing property
damage, personal injury or loss of life.
DO NOT RETURN THIS PRODUCT TO
THE STORE WHERE YOU PURCHASED
IT. IF YOU ARE MISSING PARTS, OR
HAVE ANY PROBLEMS, CONTACT
EMPIRE COMFORT SYSTEMS INC. AT
(877) 459-1583.

Page 1

Questions and Answers

  • R
    Robert MitchellAug 11, 2025
    What to do if the pilot light goes out when I release the ignition knob on my HouseWarmer HWDV080DVN-1?
    • T
      Timothy AllenAug 11, 2025
      If the pilot light on your HouseWarmer Wall Furnace extinguishes when you release the ignition knob, it could be due to a few reasons. It's possible that air remains in the gas pipes, so try repeating the ignition procedure. Another potential cause is a dirty pilot, which would require cleaning. If neither of these solutions works, the thermocouple may be defective.
  • P
    paulahansenAug 19, 2025
    Why does the burner shut down during operation in my HouseWarmer HWDV080DVN-1?
    • P
      Paul BrownAug 19, 2025
      If the burner on your HouseWarmer Wall Furnace shuts down during operation, it could be due to a couple of reasons. First, check if the gas supply has been interrupted and re-establish it. Also, ensure that the piping connection is correct according to the installation instructions.
  • S
    Steven HallAug 27, 2025
    Why is the burner burning abnormally in my HouseWarmer Wall Furnaces?
    • J
      Joshua LewisAug 27, 2025
      Abnormal burner operation in HouseWarmer Wall Furnaces can stem from a couple of issues. Check that the gas supply valve is fully open. If the flame lifts when the appliance is cold, keep it on the MIN setting for about 10 minutes.
  • T
    Troy MartinSep 2, 2025
    Why does the burner on my HouseWarmer HWDV080DVN-1 Wall Furnaces burn with yellow flames?
    • C
      Curtis ColeSep 2, 2025
      If the burner on your HouseWarmer Wall Furnace is producing yellow flames, it may be due to an incorrect piping connection. Ensure that the piping is connected according to the installation instructions.

HouseWarmer HWDV080DVN-1 Specifications

General IconGeneral
BrandHouseWarmer
ModelHWDV080DVN-1
CategoryWall Furnaces
LanguageEnglish

Related product manuals