To Next PageTo Next Page
Need help?Do you have a question about the Hoval 42-UltraOil 110 and is the answer not in the manual?
General safety guidelines, warnings, and symbols for safe operation.
Details regarding the warranty conditions and coverage for the boiler.
Provides information on additional relevant instructions and sources.
Lists applicable regulations and official approvals for installation and operation.
Guidance on selecting the installation position and safe transport of the boiler.
Instructions for properly setting up and levelling the boiler unit, including door adjustments.
Steps for attaching the thermal insulation mats to the boiler body.
Procedures for fitting the various casing parts of the boiler.
Instructions for installing the boiler's control unit and associated components.
Steps for installing the cover for the burner unit.
Guidance on attaching the siphon for condensate management.
Detailed instructions for installing the oil burner unit into the boiler.
Overview of the Hoval UltraOil® condensing boiler's features and design.
Comprehensive table of specifications, dimensions, and performance data.
Detailed diagrams and measurements for boiler unit sizing.
Information on the necessary space and clearances for installation.
Specifies dimensions for bringing the boiler through doors and corridors.
Guidelines for preparing the boiler room, including air supply.
Instructions for connecting the flue gas system and chimney requirements.
Specifies the type of fuel allowed and handling recommendations.
Safety guidelines and procedures for electrical hook-up by qualified personnel.
Table detailing appropriate cable sizes and maximum lengths.
Graphical representation of flue gas temperature characteristics.
Examples and guidance for connecting the boiler to the heating circuit.
Requirements and suitable materials for the condensate drain system.
Information on basic controller settings and heating programs.
Requirements for safety valves, their capacity, and installation.
Specifications for the charging pump and its connection to the water heater.
Requirements for setting the heating pump speed and output.
Guidelines for heating water quality and filling/replacement water standards.
Procedure for filling the heating system with appropriate water.
Note on filling the water heater if it is fitted.
Final checks and procedures for putting the system into operation.
Steps for setting the oil burner by a specialist.
Procedures for transferring the system to the operator and documentation.
Details on the screed drying function sequence and settings.
Information on settings for emission metering and manual operation.
Procedure for resetting the safety temperature limiter if activated.
Instructions for cleaning the boiler and its components by a specialist.
Detailed steps for cleaning the combustion chamber and aluFer® pipes.
Maintenance procedures for the condensate neutralisation system.
General