To Next PageTo Next Page
Need help?Do you have a question about the Hoval Uno-3 95 and is the answer not in the manual?
Further information sources and essential system manuals.
Conditions that must be met for trial operation and safety.
Regulations for installation and operation in Germany, Austria, Switzerland.
Procedures for positioning and levelling the boiler.
Steps for attaching insulation mats and panels to the boiler.
Instructions for attaching boiler casing components and covers.
Explanation of the Uno-3 as a threepass boiler and its gas flow.
Declaration of compliance with relevant European directives and standards.
Detailed technical specifications for the Uno-3 (95-110) model in Switzerland.
Detailed technical specifications for the Uno-3 (110,125) models outside Switzerland.
Diagrams and measurements for boiler dimensions.
Transport dimensions of the boiler without insulation and casing.
Specifications for boiler room dimensions, air supply, and ventilation.
Requirements for flue gas system connection and dimensioning.
Instructions for mounting the burner, including flange requirements.
Specifies approved fuels and requirements for electrical supply installation.
Information on identifying and changing flue gas regulators for temperature control.
Graphs showing flue gas temp vs. heat capacity for different models.
Flow mixing, temp regulators, safety valves, and pump settings.
Guidelines for heating water quality and filling the system.
Final checks, burner setup, user explanation, and handover procedures.
Notes on filling the calorifier for boiler operation.
Using the emission monitor key for manual operation and safety considerations.
Preparatory work, cleaning methods, and post-cleaning steps.
General parameter tables for surface operation.
Settings for DHW, Direct, and Mixer circuit time programs.
Parameters for hydraulic functions and system-wide settings.
Parameters for domestic hot water and unmixed circuits.
Parameters for mixer valve 1 and 2.
Settings for heat generator, return control, solar, and solid fuel.
Settings for buffer, main supply, cascade, bus, service, and alarms.
Overview of fault reporting codes, types, and remarks for troubleshooting.
Allocation of sensors to different system components and functions.
General