Operation
５
５５
５
Lower the vertical lift handle gradually to start drilling.
Pressing with excessive force may impede the drill’s spinning.
Always operate with cautious allowances.
２
２２
２
５
５５
５
After the work is finished, using the chuck wrench, and being sure that the power
plug is disconnected, remove the drill bit.
Clean the scraps and dust from the base.
Frequently check to ensure there are no loose parts and no malfunctions of the
desk drill. If a problem is found, ask your nearest HOZAN dealer to carry out any
necessary repairs.
４
４４
４
Turn the power switch off and disconnect the power plug after the work is finished.
Gently raise the vertical lift handle after drilling is completed.
３
３３
３
Gently raise the vertical lift handle while holding it with your hand. Otherwise, the spring
could cause the handle to return violently.
Caution
The drill continues spinning when the power switch is not turned off or the plug is not
disconnected. Keep the human body and other objects away from the spinning part to
avoid getting caught.
Caution
To Next Page
Loading...
