* The chuck clamping capacity is 0.8 to 6.0mm, so drills other than this capacity can not
be attached.
14.08
８
８８
８
Options
0.8/1.0/1.5/2.0/2.5/3.0/3.2mmЂ
K-5 Drill bit set (7 pieces)
1.5/2.0/2.5/3.0/3.2/3.5/4.0/4.5/4.8/5.0/5.5/6.0/6.5mmЂ
K-493 Drill bit set (13 pieces)
1.0/1.5/2.0/2.5/3.0/3.5/4.0/4.5/5.0/5.5/6.0/7.0/7.5/8.0/8.5/9.0/9.5/10.0mmЂ
K-494 Drill bit set (19 pieces)
0.5/0.6/0.8/1.0/1.2mmЂ
K-495 Drill bit set (5 pieces)
1-2-12 Saiwaicho, Naniwa-ku, Osaka 556-0021, Japan
Tel : +81-6-6567-3111 F ax : +81-6-6562-0024
K-50 XY-Table
K-24 Vise
Suitable for precious drilling against
PCBs and such.
Holes at regular intervals can be gotten.
Supports the object.
Mountable on the K-21 parallel guide.
K-50 usage example K-24 usage example
To Previous Page
Loading...
