Hozelock 2590 - Auto Reel Usage and Safety; Installing the Reel onto Bracket; Operating the Hose and Safety Lock; Warnings and Troubleshooting

INSTALLING THE REEL


backwards and placing the top bracket socket of the
reel onto the bracket (Fig.4a).

(Fig.4b).

Ensure that the clips are snapped into place.

your tap and connect the feeder hose to it via the
hose end connector (Fig.5).

through 180°. Turn the tap on and run the water
through the reel before using it for the first time.
Check for leaks and re-tighten hose connections if
necessary.

when left unattended on the wall (fig.6a).

bracket for stowage of hose end accessories (fig.6b).
USING THE REEL

walk away from the reel in any direction.

place for use at any required length. The hose may
be placed on the ground and will not rewind.


15 to 30cm away from the reel to release the locking
mechanism. Walk back towards the reel. Always hold


Turn off the tap and let the water out of the hose by
opening the hose nozzle/gun.
Walk back to the reel with the end of the hose and
trigger the rewind mechanism by taking hold of the
hose near to the reel, and gently pull the hose about
15 to 30cm to release the latch.
(Ensure that nothing is obstructing the hose whilst
the rewind procedure is active.)
IMPORTANT: THE HOSE END MUST BE WALKED
BACK TO THE REEL.
USING THE SAFETY LOCK
Fig 7.

of the reel.

To stop the hose being pulled out when fully
re-wound
To stop accidental rewind while the hose is in use.

symbol (Fig.7a). To unlock, turn the dial so that it
points towards the (padlock open) symbol (Fig.7b).

unattended.
Warning
Donotoperatethesafetylockwhilethereelis
turning.
IMPORTANT:
Topreventdamageorinjury:
DO NOT:
Let go of the hose while rewinding.
Always walk back to the reel holding the hose.
Place fingers or objects in the hose aperture of the
reel during operation.
Attempt to remove the screws from any part of
the product.
Remove the grey ball from the watering hose.
DO:
Remove the reel from the wall in winter to prevent
frost damage.
Keep the floor/ground below the reel as clear as
possible from water to minimise any risk of
slipping.
Turn the tap off when not in use.
Troubleshooting
ActivatingtheAuto-Rewind

15cm to 30cm, any less or more and the hose
will not auto-rewind. The easiest way to trigger the
auto-rewind is by gently pulling the hose at the reel.
Leaks

the hose to the reel

