8
CONNECTING THE TIMER TO THE TAP
Use the supplied adaptors if required. Hand tighten firmly
to ensure there are no leaks. Do not use a wrench or other
tool to tighten the nuts as this can permanently damage the
plastic components.
This product is not designed to be used in
sub-zero (frost) temperatures. During winter
months drain any remaining water out of
your timer and bring it indoors until the next
watering season. Remove the batteries from
the front panel if you do not intend to use it for
long periods.
CONNECTING THE TIMER TO THE TAP
Use the supplied adaptors if required. Hand tighten firmly to ensure
there are no leaks. Do not use a wrench or other tool to tighten the
nuts as this can permanently damage the plastic components.
This product is not designed to be used in sub-zero (frost)
temperatures. During winter months drain any remaining
water out of your timer and bring it indoors until the next
watering season. Remove the b atteries from the front
panel if you do not intend to use it for long periods.
Valve opens and closes when
batteries are first inserted but
then fails to operate when
wat e r ing m anually or
automatically.
You r Sel ect Pl us Ti mer ha s
detec ted l ow ba ttery po wer.
Repl ace wi th new ba tteri es.
The scr e e n displays “ BATT”
Your Sel ec t Ti mer ha s detected
l ow batter y power. Repl ace with
new ba tteri es.
Valve operates but no water
flows
Check your tap is turned on.
Valve works on manual but no
Auto Run (automatic) watering.
Check that the P1, P2 or P3
programs are turned on.
When I press the water now
button the valve does not
operate.
Make sure the front panel is fully
inserted into the
val ve body.
TECHNICAL DATA
Operating Press ure 0.1 – 10Ba r
Operating
Temperature
1 - 55°C
Maximum water
tem perature
30°C
Valve opens and closes when
batteries are first inserted
but then fails to operate
when watering manually or
automatically.
The screen displays “BATT”
Valve operates but no water
flows.
Valve works on manual but
no auto Run (automatic)
watering.
When I press the water now
button the valve does not
operate.
Your Select Plus Timer has
detected low battery power.
Replace with new batteries.
Your Select Timer has detected
low battery power. Replace with
new batteries.
Check your tap is turned on.
Check that the P1, P2 or P3
programs are turned on.
Make sure the front panel is fully
inserted into the valve body.
TECHNICAL DATA
Operating Pressure 0.1 – 10Bar
Operating Temperature 1 – 55°C
Maximum water temperature 30°C
To Next Page
Loading...
