HP 140

hp photosmart 140 series
chapter 4
42
transport your printer
Your printer can travel with you. Be sure to always carry the printer upright.
To transport your printer:
1 If there is a memory card in a memory card slot, remove it.
2 Turn off the printer.
3 Remove any memory cards from the printer’s memory card slot. For more
information, see remove a memory card on page 22.
4 Remove all paper from the paper tray.
5 Close the paper tray door.
Note: Make sure the printer completes its power-down cycle before you
unplug the power cord. This allows the printer to store the print cartridge
properly.
6 Unplug the power cord.
7 If your printer was connected to your computer, disconnect the USB cable
from the computer.
Note: When transporting your printer, do not remove the print cartridge.
When transporting your printer, make sure to bring the following items with you:
•Paper
•Power cord
• Digital camera or a memory card containing photos
• Extra print cartridges (if you plan to print a lot of photos)
Note: If you are going to connect your printer to a computer, make sure to
also bring the USB cable and HP Photosmart printer software CD.