b. Rotate the display panel over and place it next to the display enclosure (3).
NOTE: Pull the tape out slowly and evenly to prevent it from breaking prematurely.
Display adhesive is available in the Adhesive Kit as spare part number M26981-001.
Display panels are available as the following spare part numbers:
M16339-001: Antiglare, UWVA, FHD, 250 nits
M16340-001: Antiglare, UWVA, FHD, 300 nits
M16337-001: Antiglare, SVA, FHD, 250 nits
M16338-001: BrightView, SVA, HD, 250 nits
M16336-001: BrightView, SVA, HD, Touch-On Panel (TOP, 250 nits)
M16342-001: BrightView, UWVA, FHD, Touch-On Panel (TOP), 250 nits
M16341-001: BrightView, UWVA, HD, 250 nits
c. Release the adhesive support strip (1) that secures the display panel cable connector to the display
panel.
d. Disconnect the display panel cable (2) from the display panel, and then remove the display panel
(3).
Component replacement procedures 49
To Next Page
Loading...
