62 Problem solving and maintenance ENWW
6 Grasp the fuser handles and pull to remove the fuser from the
printer.
WARNING!
The parts on the internal surface of the fuser are very hot. To avoid
burning yourself, do not touch those parts.
7 Using both hands, slowly and steadily remove any paper from inside
the printer. Then, carefully reinsert the fuser and secure the locks.
8 Reconnect the power cable and turn on the printer.
9 Open the top cover, close it again, and then press (G
O) if the Go
light is flashing. If the Attention light is still blinking, then there is
another jam. See “To clear jams from inside the printer” on page 59
and “To clear jams from input areas” on page 60.
6
7
To Next Page
Loading...