HP 3000 Series - Page 75

l
~l_N_D_EX~(_co_n_tin_u_e_d)~~~~~-~~~~~~~~-J
Organization of this manual, v
Overview of INP operation, 4-4, 4-5
Overview of MPE configuration for INP,
p
Part numbers of INP components, 1-2
C-1
Part numbers of interconnecting cables, 1-4
Part numbers of referenced manuals, v, vi
Part numbers of test equipment, 1-5
Patterns, lighted self-test LEDs, meanings of, 5-9
PCA boards, installation of, 2-7
PCA boards, replacement of, 5-14
PCA components, location of pertinent, 5-7
PCA jumpers and switches, 2-3
PCA switches, location of, 2-4
Philosophy, repair, 5-1
Power requirements, 2-2
Power switches, location of, 2-8, 2-9
Precautions, safety, 5-1
Preparation for installation, 2-1
Principles of Operation, 4-1
Priorities, device, 2-5, A-1
Priorities, MUX Service Request, A-1
Procedures, hardware installation, 2-7
Procedures, troubleshooting, 5-5, 5-7
Programming Information, 3-1
R
RAM, 4-3
RAM chip, replacement of, 5-13
RAM chips, location of, 5-7
RAM Test, 5-4
Random Access Memory (RAM), 4-3
Rate of data transfer, 1-8
Read-Only Memory (ROM}, 4-3
Recommended sequence of troubleshooting procedures, 5-8
Recommended switch settings, DRT number, 2-5
Recommended switch settings, function switches, 2-6
Recommended switch settings, MUX Service Request number, 2-5
Recommended troubleshooting sequence, 5-8
Repair philosophy, 5-1
Repair, field, 5-13
Replacement of a RAM chip, 5-13
Replacement of the PCA board, 5-14
Requirements, power, 2-2
Reshipment instructions, 5-15
RESTART switch, location of, 2-15, 5-7
Returning PCA boards to the factory, 5-11, 5-15
ROM, 4-3
ROM Test, 5-4
Routing of the communication cables, 2-13, 5-1
Index-4
JUN 1980