Wake Time
An IT administrator can use the Wake Time screen to schedule product wakeups from sleep mode on
a daily basis. For example, the product can be set to wake up at 07:30, so the product has finished
initializing and calibrating and is ready to use by 08:00. The administrator sets only one wakeup setting
per day; however, each day can have a different wakeup setting. Additionally, to save energy, the sleep
delay can be set to turn the product off after a specific period of inactivity.
1
2
Figure 3-15 Wake Time screen
Table 3-10 Wake Time
Callout Area on the screen Information or capability that the area provides
1 Wake Time Select one or more days on which to use the wakeup setting, and then set the time
the product is turned on each day.
2 Sleep Delay Set the amount of time the product is idle before it goes into Sleep Mode. When the
product is in Sleep Mode, it uses less energy.
50 Chapter 3 Configuring the product from the Settings screens ENWW
Settings tab
To Next Page
Loading...
