Table of Contents
Table of Contents
OPERATION AND REFERENCE . . . . l-l
HP3325BTurnOnand Warm-Up .1-i
Turn-On and Power-Up Self Tests . I-1
Turn-On State . .14
Power-Down State/Turn-On Preset ,14
Warm-Up l-4
The Preset State and the Instrument
Preset Key l-5
Shii Key 1-7
Main Signal butput : : 1 : : : : : : 11-6
Main Signal Output Connectors
l-6
The High Voltage Option ,I-9
Selecting the Output Function . l-11
The Main Function Keys and
Indicators l-l 1
Data Entry And Modification
The DataKeys : : : : :
l-12
l-12
Clear Display
l-13
Error Messages
Viewing Setup Parameters
1-13
: : :
l-14
Modifying Parameter Values l-15
Frequency Step
l-15
TheEntry Keys : : : : : : : : : i-16
Frequency l-16
Amplitude l-l 7
DC Offset 1-17
Phase
Asgn ZeroO : : I : : I I I : I I
l-20
l-20
Frequency Sweeps . 1-21
Introduction to Sweeps
Start Frequency . : : : : : :
l-21
1-22
Stop Frequency
Time I I I I I I I I I
l-22
1-22
Marker Frequency l-23
Mkr + CF . . 1-23
Reset/Start Sweep
Afx2, Affi2 (Modify Ban&&h) : : :
l-24
l-24
Single Sweep . 1-24
COntinuOUS Sweep . . 1-24
Linear Frequency Sweeps 1-25
Log Frequency Sweep . l-25
Discrete Frequency Sweep 1-26
Modulation , l-26
Introduction 1-26
Amplitude Modulation i-26
Phase Modulation l-29
Modulation Source : : : : : : : : 1-29
Arbitrary Waveforms i-30
Disabling Modulation i-30
Storing/Recalling Instrument States 1-31
Storing Instrument States 1-31
Recalling Instrument States
l-31
Memory Clear 1-31
Calibration and Self Test 1-32
Amplitude Calibration
SelfTest . . . . . . . . . . . .
l-32
l-32
The HP-IB Status
Keys/Indicators/Connector 1-33
LOcal
Bus Address : : : : :
l-33
l-34
The RS-232
Switches/Indicators/Connector l-35
RS-232 Local/Remote : : : : i-36
Marker/Z-Blank (Pen Lift) /X-Drive
outputs l-37
Marker l-37
Z-Blank . 1-38
X-Drive
l-36
Synchronization butpt&’ : : : : : : : i-40
AUX 0 dBm 21-60 MHz Output
(Extended Frequency) l-41
External Reference or Oven-Stabilized
Frequency Option i-42
10 MHz Oven Output (High-Stability
Frequency Reference) l-42
External Frequency Reference 1-42