HP 3336A - Page 26

Model 3336A/B/C Operation
3-13. The Model 3336 is manufactured as one of three models identified by the letters A, B
@ or C following the model number. The difference between models is the configuration of the
front panel outputs. The outputs on each model are:
Model Outputs Accepts Connector Type
3336A 75 ohm unbal 75 ohm BNC
150 ohm bal Siemens type REL STP—6AC
600 ohm bal Siemens type V9REL STP—6AC
3336A with 75 ohm unbal Siemens type 1.6/5mm coaxial
Option 001 150 ohm bal Siemens type SQREL STP—6AC
600 ohm bal Siemens type QREL STP—6AC
3336B 75 ohm unbal WECO type 439A or 440A
124 ohm bal WECO type 443A
135 ohm bal WECO type 241A
600 ohm bal WECO type 310
3336B with 75 ohm unbal WECO type 358A
Option 001 124 ohm bal WECO type 372A
135 ohm bal WECO type 241A
600 ohm bal WECO type 310
3336C 50 ohm unbal 50 ohm BNC
@ 75 ohm unbal 75 ohm BNC
3-14. Frequency Limits.
3-15. It is possible to enter frequencies from 10 Hz to 20.999 999 999 MHz for any front
panel output. The instrument specifications, however, apply only during operation within
the following frequency limits:
Output Lower Frequency Limit Upper Frequency Limit
50 ohm unbal 20.9 MHz
75 ohm unbal 20.9 MHz
124 ohm bal 10.9 MHz
135 ohm bal 2.09 MHz
150 ohm bal 2.09 MHz
600 ohm bal 109 kHz
3-16. Frequency Resolution.
3-17. The frequency resolution for all outputs with programmable frequencies is: -
1 »Hz for frequencies below 100 kHz.
1 mHz for frequencies 100 kHz and above.
3-5