HP 3550

Configuring TCP/IP parameters using BOOTP or DHCP
1. Press M ENU to enter the MENUS.
2. Press
to highlight Configure Device.
3. Press
to select Configure Device.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO 1.
7. Press
to select EIO 1.
8. Press
to highlight TCP/IP.
9. Press
to select TCP/IP.
10. Press
to select CONFIG METHOD.
11. Press
to highlight BOOTP or DHCP.
12. Press
to save the setting.
13. Press M
ENU to return to the Ready state.
Manually configuring TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, default gateway, syslog server,
and idle timeout.
ENWW Network configuration 53