*SRE
Status Bit "0"
"1"
B7 (always t))._ - -
B6 (RQS)
Not ma kabie
B5 (Error)
Mask B5 enable B5 SRO
B4 (Alwa_y!OL
- -
B3 (End status) Mask B3 enable B3 SRQ
B2 (Ignore trigger)
Mask B2 enable B2 SRQ
B1 (End of Conversion) Mask B1 enable B1 SRQ
BO (Meas. complete)
Mask BO enable BO SRQ
SOFTKEY LABEL: NOT ASSIGNED
The *SRE command masks the SRQ (Service Request).
SYNTAX:
*SRE
VALUE:
In the default instrument state the setting is *SREO (all zeros: all bits
masked). *SRE ranges from *SREO to *SRE255. The *SRE command
must be set in accordance with the following table.
For example:
*SRE
Description
*SRE1
*SRE2
*SRE3
*SRE4
*SRE8
*SRE32
*SRE45
Enable BO for SRQ
Enable B1 for SRQ
Enable BO and B1 for SRQ
Enable B2 for SRQ
Enable B3 for SRQ
Enable B5 for SRQ
Enable BO, B2, B3, B5 for SRQ
EXAMPLE:
OUTPUT 717;"*RSE1"! Enable BO for SRQ.
4-51
To Next Page
