HP 4284A - Page 111

NNNNNNNNNNNNNNNNN
1 ABS
NNNNNNNNNNN
1%
NNNNNNNNNNN
OFF
6. Select and press a softkey to select the deviation mo de for the
primary parameter.
7. Move the cursor to the (DEV) B eld. The following softkeys will
be displayed.
NNNNNNNNNNNNNNNNN
1 ABS
NNNNNNNNNNN
1%
NNNNNNNNNNN
OFF
8. Select and press a softkey to select the deviation mo de for the
secondary parameter.
System Menu
The system menu on this page allows you to perform the following
control functions.
Load/Store
Clear Setup
Printer
System Reset
These functions, except for the clear setup function and system reset
function, are the same as the functions on the system men
u on the
MEAS DISPLAY page. (The description of each function is given on
page 3-19, system menu.) So in the case of the clear setup function
and the system reset function, the description and setting pro cedure
are given, while in the case of the other functions, only the pro cedure
is given.
Load/Store Function
Perform the following steps on the MEAS SETUP page to store the
control settings to the internal non-volatile memory or the external
memory card, or to load the control settings from the internal
non-volatile memory or the external memory card.
1. Set all controls.
2. Move the cursor to the SYS MENU eld on the MEAS SETUP
page.
3. If you are using a memory card insert the memory card into the
MEMORY card slot.
4. Press
NNNNNNNNNNNNNNNNN
STORE when you want to use the store function. The
message Enter record number to STORE will be displayed on the
system message line.
4-14 MEAS SETUP Menu