HP 4284A - Page 220

Each data format has a dierent data transfer rate. Table 7-3 shows
the typical time required from sending the FETCh? command or the
MEM:READ? DBUF command to enter the data using the ENTER
command with an HP 9000 series 300 computer.
Table 7-3. Data Format and Data Transfer Time
Format Data Type Time
ASCII Data without BIN No. 10 ms
Data with BIN No. 11 ms
List Sweep Data (10 p oints) 75 ms
Data Buer Memory (128 sets of data) 960 ms
BINARY Data without BIN No. 8ms
Data with BIN No. 8.8 ms
List Sweep Data (10 p oints) 34 ms
Data Buer Memory (128 sets of data) 406 ms
Remote Control 7-19