HP 4284A - Page 271

FUNCtion Subsystem
:DEV < n > :REFerence
The :DEV < n > :REFerence command sets the reference value for
deviation measurement. The :DEV < n > :REFerence? query returns
the current reference values.
Command Syntax
FUNCtion:DEV < n > :REFerence < value >
Where,
< value > is the NR1, NR2, or NR3 format
< n > is :
1 (decimal 49) Reference value setting for primary parameter
2 (decimal 50) Reference value setting for secondary parameter
Example
OUTPUT 717;"FUNC:DEV1:REF 10"
OUTPUT 717;"FUNC:DEV2:REF 2E-3"
Query Syntax
FUNCtion:DEV < n > :REFerence?
Query Response
Returned format is :
<NR3><NL^END>
Example
10 OUTPUT 717;"FUNC:DEV1:REF?"
20 ENTER 717;A
30 PRINT A
40 END
:DEV < n >
:REFerence:FILL
The :DEV < n > :REFerence:FILL command executes a single
measurement and enters two measured values (the primary and
secondary parameters) into each of the reference values for the
deviation measurement.
Command Syntax
FUNCtion:DEV < n > :REFerence:FILL
Where, < n > is
1 or 2 (Both reference values are measured simultaneously.)
Example
OUTPUT 717;"FUNC:DEV1:REF:FILL"
8-30 Command Reference